26 MHz TCXO Interface Checks for Clipped-Sine, CMOS, and Frequency Error
Two 26 MHz TCXOs of the same size may have output waveforms that suit different receiver requirements. Confirm that the receiving chip gets a valid clock by checking amplitude, bias, load, control pins, and the frequency-error budget separately.
1. Start with the receiver specifications
Check the clock-input section of the chip datasheet for allowed waveforms, input amplitude, common-mode voltage or bias, coupling requirements, and absolute maximum ratings. The input pin can belong to a separate power domain even if both ICs use the same supply voltage.
For CMOS outputs, check VOH, VOL, edge rates, and duty cycle at the specified load. For clipped-sine outputs, check amplitude at the datasheet load and confirm receiver bias. If the datasheets use Vpp, differential values, or typical values, align the definitions before comparing.
2. Check the input circuit after the AC-coupling capacitor
Suppose the existing board connects to the receiver through a series capacitor. The capacitor blocks DC, and the receiver input still needs a valid bias. Recheck the existing capacitor and bias network if the replacement has different output impedance, amplitude, or recommended load.
Record measurement points, probe loading, coupling mode, and chip power-up sequence. Waveforms at the oscillator output and the receiver pin can differ. Check the conditions at the receiver pin directly.
3. Convert ppm to hertz and budget the error at 26 MHz
26 MHz × 0.5 ppm = 13 Hz. Before using the result, determine what the 0.5 ppm specification covers. If the system allows ±1 ppm total, an initial error of 0.3 ppm, a temperature effect of 0.5 ppm, and other nonoverlapping limits of 0.4 ppm add up to a conservative 1.2 ppm, or 31.2 Hz. That exceeds the 26 Hz limit.
These example values are hypothetical. When the manufacturer's total frequency error includes initial error and the temperature term, count each once. A temperature stability figure by itself covers only the conditions specified for that figure. Check the applicable full-condition, lifetime accuracy separately.
4. Verify the tuning pin and recovery timing
If the existing board uses voltage tuning, identify the candidate as a fixed-frequency TCXO or a VC-TCXO. Check tuning voltage, polarity, range, input impedance, and the voltage available from the system. The original tuning signal requires an actual tuning input to control frequency.
During acceptance, check cold startup, steady-state output, sleep and wake behavior, and frequency error over the required temperature range. Use the example budget as a review template and retain the exact order code and manufacturer guarantee conditions when recording qualification results.
Calculation and record table
| Hypothetical limit | ppm | Equivalent at 26 MHz |
|---|---|---|
| System target | 1.0 | 26Hz |
| Residual initial error | 0.3 | 7.8Hz |
| Temperature term | 0.5 | 13Hz |
| Other nonoverlapping limits | 0.4 | 10.4Hz |
| Conservative total | 1.2 | 31.2 Hz, exceeds the target |
References and applicability
This technical analysis uses public documentation and was prepared with AI assistance. All worked examples are hypothetical. They do not establish product specifications, measured results, or compatibility. For a specific device, use the exact ordering configuration, the latest manufacturer datasheet, and board-level validation.
See the manufacturer reference Texas Instruments SNAA377, December 2025, Differential and Single-Ended Signal Termination Guide, Sections 2–4.
Related selection guides
For help documenting these parameters in a BOM or RFQ, see MERLIN’s TCXO output interface and selection documentation. Confirm specific part parameters against the applicable manufacturer datasheet and project validation.
